Using textured PEI?
A look into machine start gcode:
;===== for Textured PEI Plate , lower the nozzle as the nozzle was touching topmost of the texture when homing ==
;curr_bed_type={curr_bed_type}
{if curr_bed_type=="Textured PEI Plate"}
G29.1 Z{-0.02} ; for Textured PEI Plate
{endif}
aka it is shaving -0.02 off Z if you use textured plate, in order to make it ram home all the PLA into the nooks and crannies. An extra -0.02 off a 0.10 initial layer means that auto leveling and the beds speckled peaks and valleys need to be within 0.08 tolerance.
You may unironically find relief by lying to your printer and saying its got a smooth bed