Hello
Thank you for the ideas.
Logically if it was an external issue both prints would show the issue, printing from slicer vs sd card wouldn’t fix an external issue?
The above photos are the exact same gcode, filament, printer location. The printer wasn’t reset or powered off between prints. Prat was removed and then reprinted from the sd card.
But just to confirm the printer is on a very strong and heavy workbench and the issue has happened on multiple filaments.
A factory reset has been completed a few days ago.
@Hurla seemed to have a similar issue where a reprint from an sd card showed no issues of the frist print. Unfortunately no solution was given.
Thank you