Not sure if related, i got my A1 on 5/14 and went through the whole setup/calibration and noticed my prints were off, and when it was doing the head cleaning that it wasnt doing it on the top tab but about half an inch down on the main plate, then it’d go over to the left to wiggle across the brush but was also to far down the plate and was just doing it over nothing.
I turned everything off, flashed a new FW that came out yesterday, and re-calibrated and now its doing what it should where it should.
Slightly annoyed it rubbed the texture off in a spot at the top of my actual build area not in the upper tab like it should when it was not working right, but shouldnt affect anything i hope.
So i’m not sure if this is the same problem you’re having or not.