I am getting this effect which I think Ive narrowed down to ringing/ghosting I think. I’ll include photos.
What ive tried:
-Updated the A1 to the latest software
-Updated Bambu Studio to the latest software
-Bed Tramming as instructed here (A1 mini Bed Tramming | Bambu Lab Wiki)
-Lubricated and cleaned everything per (A1 mini Maintenance Guidelines | Bambu Lab Wiki)
-Re-tensioned the Y belt and the X belt per (A1 mini Maintenance Guidelines | Bambu Lab Wiki)
-Followed the instructions for Ringing via this guide (Possible Printing Problems | Bambu Lab Wiki)
-Ran bed leveling and vibration compensation calibration several times
-Ran the flow rate and flow dynamic calibration via Bambu Studios many times
-Followed this guide step by step (First Layer Not Sticking: Causes and Solutions | Bambu Lab Wiki) Cleaned the bed with soap and dried it and went over it again with ISO
-Ensured I have the right bed selected in Bambu Studios (Textured PEI)
-Tried different brands of filament including eSun PLA and Sunlu PLA
-Tried different sliced models
-Tried 2 different .4mm nozzles both official Bambu
-Tightened the 3 screws behind the hotted and the 4 screws on the other side per (A1 Series First Layer Print Issues - First Layer Too Low, Hotend Moving | Bambu Lab Wiki)
-Ensured the heating assembly buckle is fastened correctly
Other info:
-Its connected to AMS Lite Hub
-No Mods on the printer
Sitting on a sturdy low wooden storage unit but I do have an A1 on the same unit so im not sure if that can be an issue
-Using Textured PEI Plate only
Ringing Torture.gcode.3mf (215.0 KB)
