A1 Print issue on one section of model

[Cyrodilian]

I’m new to printing and have been enjoying the A1 and getting good results.

I’ve recently purchased a .2 nozzle for some smaller figures and used the settings recommended for miniatures by Fat Dragon Games.

This model came supported, but after a failure, I created my own support using recommended settings I found online. Both looked fine on the slicer but one arm of the model printed as you see in both cases. Everything else looks good.

I wondered if I could get some advice as to what’s happening. I’m not experienced enough to know if it’s an issue with the model, my settings or lack of support. I just want to understand what I can do better. Printed on Bambu Matte PLA.

strong text

[MalcTheOracle]

A screenshot of the slicer with supports showing would be helpful.

It seems likely the support is insufficient.

It is likely you would benefit from tree support sufficiently large enough to touch all points that does not have anything underneath it.

I would also recommend adding modifiers to cover the more delicate areas like the hands and between the legs and increasing the walls and infill.

[Cyrodilian]

Thanks so much for the helpful response. Here are the two versions I tried, one with the original supports and the other my attempt at supports. The actual result was pretty similar for both.