Hey fellas I seem to be having an issue with my A1 and I’m hoping someone here might know something to help out.
Basically I had a majorly failed print that damaged the wires going to the hotend and ended up replacing it (no big deal). However ever since this incident I have also had the following issue with the printer not homing correctly and now not printing correctly (though please note that it does appear to feed filament just fine through the new hotend).
Does anyone know what causes this issue and any possible fixes?
Any assistance is appreciated, I have been trying to deal with Bambu support directly but honestly not getting the best help out of them regarding this at the moment due to time differences.
Please note that the picture is an example of the print failure I had, this is not a direct picture as I did not take one at the time but same issue.
I tried posting a video to show it but I am to new to be allowed to at the moment so Youtube link (if I did it correctly): https://youtube.com/shorts/387dlrrMw38?feature=share