Hi
I thought id give adapted cubic and it seems to be creating floating infilll. Is this something to do with my model, or just a normal error inherant in the algorithm? Is there anyway for me to get around this somehow does anyone know?
thanks for any help
I assume you’re referring to these sections noted by the green arrows.
I’ve never seen that happen unless you had modifiers in the model.
Here’s what I would check in no particular order:
Try rotating the model on the plate by 30-45 degrees and see if the infill changes.
See if using using aligned rectilinear creates the same gap.
Try changing the angle of the infill and see if that has an effect.
Good luck🍀 and let us know how you make out so that everyone else can learn.
hi - yeah those red bits that seem to float above nothing!. Unfortunately I wasn’t looking when it printed, but it didn’t actually fail! - I’ll have to give it another try tomorrow and see what it does
took a look at the print again, and it does seem to be a bit of a mess around those layers, but it sorts it self out and doesnt fail as i guess theres another support in general. Must be just one of those weird algorythmic glithes i guess
