Hi guys! Have some problem with printing model with Bambulab PLA-AERO Main problem with retraction how I think, there is always leakage of filament from hot-end. All settings based on manual from Bambu wiki, filament was dried for 8 hours based on Bambu wiki as well. When printing retraction tes…

AERO PLA Retraction problems

Rossero November 20, 2024, 10:32am 2

isn’t the whole idea of PLA aero? that is foams/expands to save weight, I would think that stringing is almost inevitable.

But just a quick search found this topic/guide:

Good luck!