Anyone solved this issue? I have the same problem. My AMS slot 3 prints 2 min with PET-G, then the error “motor is overloaded”. My filament is not stuck on the roll, or in the ptfe-tube. Neither is the nozzle clogged. So I can’t find out what the issue is since everything seems well. The AMS is new and has not been used that much so far…
It prints 2min in slot 3 - error - retry and it prints fine with gods extrusion 2 min - error…
OBSERVE: When I tried to use the same PET-G without AMS there was no problem to print.