it seems many others are having same issue looked for a resolution and did not see one .so i am asking if anyone have a fix for this issue.
i have replaced the motor i have cleaned the hub, tried five different brands of filament with the same issue. while printing the printer randomly stops and retracts the filament then sometimes feeds it back in and contunes the print. other times it retracts the line then notice that the AMS assist motor is overloaded all i do is hit retry and it runs again for about 5 minutes
does anybody have a fix
Have you examined the feed tubes?
1 Like
I printed out a tube that better guides the ptfe from the back of the AMS to the printer. Working much better since i did that, especially since one of my AMS’s has a fairly long run to the printer.
1 Like
I forgot to say that but have replaced them two times and the ends also