AMS feed when filament empty and print finnish

Bambu Lab P Series Troubleshooting
1

Hi Folks,
i printed an object with the last few meters on my spool in the AMS.
The AMS runs out of filament and try to feed.
(So far so good).

Now, the print is finnish while the rest of the Filament stays in the PTFE Tube.
(So Far so good)

But one of the AMS Motor runs all the time. and never stops.

I my case the motor runs the whole Weekend. I’ll Think there must be a Runout-Timer implemented so the Motor doesen’t run all the time.

My Printer is an P1S with the AMS

BR
CharlyMai

2

Tried pulling the power on the AMS and restarting I assume

3

This happens to me too I manually triggered a spool re-read to get it to stop.

1 Like