The AMS spool graphic in the device page has updated. This is now a schematic for the AMS Lite, but mine is an AMS1 on a P1S.
It would be great if it could show as inline as it took me a while to figure out the spool orientation - showing the Lite schematic for the 1 setup is not intuitive.
I use the number keys to apply filament in the slicer and without visual on my AMS it took me a while to figure out!
Would love to see a more real world representation!
Same for my X1E, but correct view for my H2D (same as previous SW ver). Also worth noting there’s no humidity feedback with the incorrect view.
Thanks! Good to know it’s not just me.
I should add that my P1S is on firmware 1.0.7.00.00 and AMS is on 0.00.06.49. I’ve held off updating for now.
Same problem het for my X1E and my two AMS.
Firmware X1E: 01.01.02.00
Firmware on both AMS: 00.00.06.44
I have the same issue on my X1E showing the AMS Lite. As first I thought it was from have a AMS-HT connected which is not supported yet but disconnecting this did not help.
Having the same issue. I miss the humidity view, hope it gets fixed soon.
The latest release of 2.3.1.51 fixes this issue.
