AMS2 Pro and bambu refill filaments

I have been printing some big jobs in PETG black basic, so I run two spools of the same filament in the AMS 2 Pro so when one finishes the other starts automatically. These rolls came from Bambu on spools.

I recently purchased several rolls of PETG refills. When the second last spool ran out I replaced it with a refill roll on the same spool. I didn’t replace the tag which indicates what it is because it was the same type. The AMS didn’t recognise the new roll of filament so I typed it in. So there were 2 spools of PETG basic black, one that came on a spool and was currently being used and a refill spool. When the one in use ran out it didn’t start the refill automatically. I tried the auto load and it still didn’t load. I tried telling it to load from where the refill roll was but nothing happened. Eventually I placed the refill roll in the spot where the other spool was and it loaded but it still does not recognise what it is.

Do I have to replace the clear tag on the spool evenif if it’s the same type of filament?

1 Answer

1

The refills have RFID tags on them. I don’t follow what you mean by “I didn’t replace the tag” - you would actually have to physically rip it off the refill’s cardboard core.

Anyhow, the AMS won’t read an RFID tag in the middle of a print. The auto-resume function only works if both spools are already in the AMS when you send the print in the first place.

If you run out mid-print, just put another spool of the same material into the same AMS slot, stick a couple inches of the filament into the feed hole, and hit resume. No need to update anything from the filament screen.