I want to install my H2C on Cura. Anyone have success with adding the H2C or H2d to Cura? If so could you share the printer settings within Cura? I only need the right nozzle to work for cura, any other prints I’ll do on BBS. I am at the point where I am gonna sell the H2C if I can’t get Cura to work. The reason is after hundreds of tests I can’t get anywhere close to the same results I get with TPU as I do on Cura with my MK3S. Seams are just way to noticeable. On Cura they are smooth as can be and thats with no retraction! Thanks
No idea about H2x in Cura but an idea to rule out the slicer:
I think you can add your MK3s in BambuStudio and see if you then get the same ugly seams.
1 Like