What’s up y’all? Question for y’all…
I’m using an A1 Combo w/ AMS Lite to print your Sugar Skulls Jason mask and I got around 30% of it printed and my printer made an awful jamming sound like the gears were being stripped. I wasn’t in there to see what happened but hear it. After that noise the nozzle sweeper position and come back out and down to the print and just sat there like it was waiting for the Gcode line to give it the next move. It extruded a tiny amount of filament which made a little puddle mound where the nozzle was sitting. I check the print and there’s no high spots where it could have caught on. This has happened to me before and I can’t figure it out. Any help is much appreciated thank y’all in advance.