Bambu filament misidentified

[lyonsfive]

I’m not sure if this is the correct category or not… I transferred filament from a larger generic spool onto a Bambu spool. I removed the label on the Bambu spool, yet the filament is identified as Bambu PLA-CF, vice Generic PLA. I cannot then change the filament type. Where else is Bambu filament labelled as Bambu?

[PrinterMcgee]

At the end of the spool there’s an RFID chip. It looks like this:

If you can’t pull it out you can turn off the ID process and then set it to what you need it to be:

[lyonsfive]

I didn’t realize that was an rfid. I was able to turn off the AMS setting. Thank you!