hi. I do not agree, there is a lot they can do. but as said it will be at a different level than FDM. in SLA or better MSLA ( or what ever you want to call the vat printers since they are not real SLA as such: no laser) you would need to adapt your settings to the resin, there is no universal setting, its all resin specific. for resins ist almost all about settings so BBL will have to repeat its development an do TONS of tests with a certain resin to find the best settings and way to print in all circumstances. but this will then only be for this resin. there are a few hardware things they can try like said vat heater, stirer, pumping, filter, tilting, fep types, fep inflating, force sensors, cameras, etc… as long as they dont do the mistake nearly all resin manufacturers are doing lately it seems to me is the single COB UV lamp, what a ■■■■. the most important is UV consistency over the entire Display surface. just get a UV meter an measure. I found HUGE difference on certain models, up to 50% variation from center to edge of the vat. this cannot work.