Well guys, it finally happened to me - BambuLab supported ghosted me!
My H2C developed a knocking noise when the toolhead would change direction moving diagonally from front-right to back-left. This noise was not there when moving in the other diagonal. At the same time, the power supply fan was on its way out too.
I created a ticket and was able to get a power supply replacement. However, when it came down to the knocking noise things were not a rosy.
I posted video after video showing the knocking noise. Bambu was reviewing the videos and responding until…
I was out of town for three days, during that time I received a reply asking me to check the A/B motors. When I came home, I checked them and replied to the ticket. Since then, crickets. It’s been over a week now.
Does anyone have any advice on how to get them back? The printer is just sitting.
Thank you.