Hi all, been printing for about a year with Prusa so not a complete noob ( but not far away!! ). I have had my X1C Carbon for about 2 weeks and have printed about 40 hours in total with PLA and 0.4 nozzle. After having an issue with a print with missing letters on a logo it was suggested by Bambu …

Could you please post pictures of your modd and provide links to parts. And also perform a VFA test from Orca. Thanks You can buy gaskets here : https://fr.aliexpress.com/item/4000880527421.html and pulleys here : https://fr.aliexpress.com/item/33023133633.html

Wtf dude Hello, don’t stress so much, what do you want? I’ll publish if I want This pictures are with manual tensioner In real life it looks better than in the photo The corners are also square, it wasn’t like that before [IMG_0115] [IMG_0113]

Measuring the motor load in the firmware Can we do that on the Bambu printer or do we need the X1 Plus firmware installed? This should be something end users can view in the stock Bambu firmware. Anyone know how? Also, I am suffering from Banding as well. I have a forum thread on my current pro…

After a long communication with Bambulab support, I finally received a response. " Please our printer is fast printer and in order to do this it has to be run outside the natural resonance zone of the frame and motion system. You need to have on the outer wall above 160 mm/s or very very slow. A …

Support staff will send you a 3MF file to print. The print is this cube here. Granted my printer is having some trouble at the moment. [image]

Take the manual tensioner from me on makerworld. I have 0.05mm max. I think the springs are not good [image] X/Y Lager defekt German ein anderer hat jetzt versucht mit anderen gleitlagern zu arbeiten, er meint alles was mehr als 30gramm mehr ist als Original, arbeitet d…

this manual tensioner doesn’t allow to tilt pullet to center belt on pulley.

I meant pulley. But this might help: https://www.printables.com/model/459456-bambu-lab-printer-x-y-squareness-check-adapters

My belt doesn’t run in the middle either. This is probably because the frame is not 100% square. That’s why they have such long treads

I wonder if there’s any way Bambu can do something like monitor the motor resistance which may fluctuate slightly as the belt notches make contact and then apply a slight axis over-correction to cancel it out. Or, perhaps some kind of calibration mode where it prints a low wall and then uses the li…

Banding / Ringing type artifacts?

Bambu Lab X Series Bambu Lab X1C

palmer_inc February 22, 2024, 7:36pm 485

Take the manual tensioner from me on makerworld.
I have 0.05mm max.
I think the springs are not good