Chamber light goes off even in manual mode

Bambu Lab H2 Series
1

I am on firmware 01.01.04.00, and i believe it to be the latest.
Chamber light goes off after a while in manual mode.
Switching to energy saving and back to manual does not change the light behavior.
So, my time-lapses are always dark :frowning_face:
Did I miss some setting, or do I have to reset my printer?

2

Yea I would ask support about that one. My printer complains if I try to turn the light off while a print is in progress. The printer seems to always turn the lights on when a print job starts.

1 Like
3

As does mine. I have never seen it try to “print in the dark”, it always comes on. I believe this is to assist the AI in detecting issues.

4

Solved…
I did a factory reset.
Now, light comes when print start and stays on and stays on until I switch it off.