Change of size

[Salonooz]

@MalcTheOracle

If you placed the plug and socket at an imagined height of 100.1mm, and you are printing at 0.2mm layer heights that 100.1mm position isn’t 100.0mm or 100.2mm, so the slicer has to guess. It could go above to 100.2mm or below at 100.0mm.

i c… hemm… i must recheck the design again than…
because when I checked the middle hollow, it should 50x50mm… but is not, is less than that…

it just happend today… argghhh…