Cruise Ship Print

16/8

Single Plate 1:1000 Multi coloured version looking quite promising too. Projected around 20hrs print time.

Looking forward to trying it once I have ironed out any issues with the single coloured version.


21/8 8:18
Nearly 21 hours, 10 colour print now starting - doing print on cool plate to allow for a few pauses.

If this print fails might try printing both Ventura and Azura at the same time as two ships of this basic design just about fit on - only adds about 7 hours to the print time - which sounds like the right amount of time when you consider that 7 hrs is how long the single colour version took.
This would also push the waste ratio down to below 50%.

7 hours in to print - about another 13.5hrs to go… looking good so far

22/8 05:30. Print looking good, just one fault with one of the centre pool light, only a few hrs to go.
Had to switch to wyze camera because lost x1c connection - another Bambu cloud issue I assume.

22/8 8:44 - print finish an hour or so ago - quite pleased with it.
Issues were

  1. Loss of one of the lights around the middle pool
  2. Covered internal pool surface not that good
  3. Some colour bleed off the yellow into the white on the front canopy and radar tower - the first colour bleed I have noticed so far in all of my prints.
  4. A few stray silver fibres at the bottom of the overhang above the cabins.
  5. Some fine stringing between lamps
  6. Steps at rear look a bit messy
    7.Front canopy middle support missing - so some bridging artifacts
  7. Bottom surface of rear overhanging bar a bit messy and also underside of bridge - so may need a bit more support added.
    9 Not really keen on 21 hr prints - so will probably split the model into 4 separate sections - that can either be printed individually, or together in combinations as required. Fixing will be via M4 bolts from the bottom.







Timelapse