Hello, I need some advice. I have two gears to print for an agricultural grain machine. Since I still have the PA-CF spool that came with my X1C, I decided to print them with it. I bought a 0.6 hotend, dried the spool, and printed a Benchy to see how it would turn out, and it came out really clean.…

What’s the diameter of the hole? Can you just run a twist drill through it to open it up to the right size? If you printed an object that’s 10cm across, that 0.25mm average error is only 0.25%, which is actually pretty darn good. FDM printers cannot produce “tight” tolerance prints. Even if the pr…

My diameter needs to be 16mm, but unfortunately, I don’t have the option to go over it again with a drill bit. Usually, when I print with PLA or PETG and need a relatively precise diameter, I always add 0.2mm in Fusion 360 to get the correct dimension, and it works well. That must correspond to the …

Have you calibrated the shrink for the filament your using?

Is it possible to do that? How do we proceed?

Here is a link to it. Make sure you calibrate your filament first. [image] Compeastion x y z Bambu Lab Software im found solution for problems… for X Y and Z, but still not SKEW compesation. here is litte tutorual. if you have problems for printig correct parts dimensi…

Dimension issues with PA-CF filament

Bambu Filament and Accesories Filament

silver118822 March 26, 2025, 4:07pm 6

Here is a link to it. Make sure you calibrate your filament first.