In my experience with the same filament, eSun profile is just wrong - too high temp and too little cooling.
It prints better with Bambu generic PETG profile - select it and then try printing temp tower. This filament likes a little lower temperature and high flow rate and speeds.
I’m printing at 235 -240, bed 70, flow rate up to 20.
Check this video: https://youtu.be/fhvpshjHYk4?si=mt3j-5418fLHFjQy
I got almost the same values at calibration in Orca slicer.
Only problem I encountered so far is this filament sticks like crazy to textured PEI plate.
EDIT: temp tower printed before calibration with bambu generic PETG profile.
2 Likes