Ok, the print was 99% completed, when my phone sent me an error saying the filament failed to extract. SO i went and checked and the AMS slot 3 had a red light, i could see the filament all the way into the print head, so i hit play on the screen and it pulled the filament out. BUT i could tell it snapped somewhere in the print head.
I started a test cube and it pushed filament out the nozzle, so it must have broken right before entering the nozzle and the filament just pushed it through. The print looks fine
but my question is, could i still have a clog even though the print looks fine? and how do i get filament OUT of the nozzle if it does break?
EDIT: it seems no matter how many prints i do, slot 3 cant pull the filament out. SO far 3 prints, and the red light goes off, then i have to hit “play” again, and then it can remove it.
something is wrong with ams slot 3
thansk