On every Klipper based printer I use, I can “play” with speed, flow and nearly all other parameters, so it is easy to adjust and easy to see the tendence if you change settings and you can with this experiance change the slicer informations for the next prints. I bought this X1C, what is really not bad… but it is like a printer for a “housewife” with no interest to adjust something. Lots of filaments but more than that, lot of time is lost with printing with this printer, so, I only print small things on it and things with multifilament and use for all others my Klipper based printers. It is possible, that the direct change while printing is not as correct as a code of the slicer, but you can see the tendence of change and you can make, that a whole print is not for the dustbin. At excample, you have at the end of a 4h print an overhang and the settings are bad. With Bambu printer, the whole print is damaged, with a printer I can change settings, I can change it directly and the print is ok. There is no reason not to have this possibilitys. Could be on an advanced setting side on the screen. The others with only “let the printer do experiance” do not have to use it.
1 Like