I hope this may help someone.
I had a filament jam in the gear feed housing of my P1S.
I removed the filament jam, re-assembled and the filament still would not load.
On further ivestigation I noticed that the extremely small magnet on the filament latch had become disloged.
I replaced it and was confident that this would fix the problem.
Not so, after re assembling filament still wouldnt feed.
After scratching my head I wondered if the electronic pcb board switch was polarity sensitive.
I removed the magnet again, reversed it and now everything is working as normal.
As I said I hope someone may find this tip usefull.
3 Likes