Firmwareupgrade crashed AMS?

Bambu Lab A1 Series Troubleshooting
2

Hey guys,

I’ve finally cracked the code after a bunch of testing! If you’re having similar trouble, give this a shot:

  1. Power down your printer.
  2. Unplug the AMS Lite.
  3. Switch your printer back on.
  4. Factory reset it.
  5. Take all the filament out of the AMS Lite.
  6. Power off the printer again.
  7. Plug the AMS Lite back in.
  8. It should now show up in Bambu Slicer.
  9. Load your filament.
  10. You’re good to go!

I’m relieved it was a simple fix. Hope this helps you too!

P.S.: I upgraded again to 01.04.00.00, so i think this solutions helps without downgrading to another version.

Good luck :slight_smile:

1 Like