Warning/Disclaimer
If you want to try this, you should have some more informations :
- does it print : yes
- does it print faster : yes
- does it print pretty : yes
But…
The nozzle is 1.9mm lower, this have some annoying consequences :
- the plastic part that wipe the nozzle is hitted hard, mine did not crack but I suppose it could happen
- the Bambulab detect something wrong and display a warning message, saying the nozzle appear too low, and to verify if there is not a plastic sticked to it (but just a warning, you can ignore it)
- last and related to the previous the first layer is squished
I manage to mitigate this bad effects by cutting the inside tube of the hotend but it is still not perfect and must be done with care.
