Flush volumes, prime tower, filament load purge

[thedevilsjester]

@Jeepin95

So it sounds like the primary advantage to enabling this is that it also enables the option to flush into infill or support?

You should not disable prime tower unless you have a very specific reason to do so.

You can read my reply to another post to understand why, and what the prime tower is for.

Print ignoring color transitions

You should be able to turn off (most) of the purge by setting the flushing volume multiplier to 0 (or something close); but I would not turn off the prime tower if you are doing multiple colors or filaments (unless you are doing a full bed print and just want to yolo it). This could negatively impact the quality and strength of your print (and it the worst cases, cause a print failure) When a nozzle is at or near temperature, doing nothing, even for a second, it has the potential to ooze out a…