H2C Y-Axis squeaking noise - 4 month old

Hi all,

Can anyone make heads or tails of this issue?

H2C - 4 months old. Maintenance done every month using bambu products.

Had some squeaking last week, got the usual Maintenance notification today. Did the full job and still doing it.

Ive managed to narrow it down to the back-right end of the printer and think it could be the motor.

Below is a video of a nozzle reset. Noticed it starts to make the noise once the Y axis is half way.

It also has the same noise when moving the toolhead manually when off.

Cheers

It is usually belt tension or the wheel/cap on top of the stepper being crooked

I can’t say anything about your specific printer

Is belt tension something that naturally occurs or does it mean an underlying issue?