So I am printing PLA on left, TPU95a on right.
The sequence goes like this.
TPU prints layer, finishes layer, goes to cutter, cuts, switch to pla.
Pla prints and finishes layer, goes to cutter, cuts, switch to right , tpu nozzle, CUT THE TPU AGAIN and proceed to print the prime tower.
Im lost.
Im uploading a video of the behaviour. ALSO in the video, you can see that while the head goes there, it extrudes filament, same issue that leads to hairy prime tower, nozzle purges in air and then moves in tower.
on latest firmware/latest bbl studio. stock settings except from use pla as support for tpu.