H2D poops on bed instead of chute during change

I didn’t see any recent replies to this. Also, when things are working, people don’t usually post about that. I’m not sure when it started working OK, but my H2D now prints Bambu PLA multi-color without leaving a mess on the back of the build plate. I haven’t been doing multi-color in a few weeks but have gottne both firmware and software updates. For the past 3 days, I’ve been printing with Bambu Lab PLA marble, two-colors. No mess at all on the build plate or the prime tower. I also finished a Bambu Lab PLA basic 3 color print with no issues. I have NOT adjusted any slicer or filament settings from whatever was default or set in the .3MF model file.

I’m happy again :slight_smile: