During multicolor prints, I’m having quite a lot of alerts that the purge is built up ( it did ). i feel as though the purge levels are to high and or the doors not opening fast enough .
has anyone played with the purge values ?
and is having the door open faster an option ?
I find the H2D poop chute backs up often, I have to do some proctological surgery and clear the poop chute by hand every 10-20 prints. Usually TPU has the hardest time clearing the chute fully. I do have a down-pipe so that might be a contributing factor though.
I have a shoot made as well with PETG with aluminum tape in the shoot to stop the purge from sticking the back up is caused on top of the little door