Hello! In the past few months I’ve noticed that removing tree supports has gotten a lot easier and the results on the print quality at the interface seems to be much nicer. Looking at the interface layer I can’t say for certain but it seems different in some manner? I’m noticing smaller tips and a seemingly better interface design. I’ve only used auto tree supports on models. Anyone else see a noticeable improvement recently or am I just overanalyzing this? I don’t have anything to directly compare that I can think of, but I’ve had my A1 since near launch and while it was never bad at tree supports, it’s much better now it seems.
I looked at a few change logs as well but didn’t see anything that stood out to me about this