Help tunning PETG-CF settings

[Barryg41]

There is a lot of info in this thread.

Help Tuning Bambu PETG-CF

I need help with tuning my Bambu PETG-CF. In this thread I have the same model printed using orca-slicer calibrated settings, as well as the stock Bambu PETG-CF presets I went through the OrcaSlicer calibration process and did some tuning, but my print ended up quite bad! Filament was dried for 8h at 65c as recommended, resulting in a RH of about 15% in the chamber it was dried in. Placed in an AMS at 10% RH with extra drying beads. Model tested: 2x2 gridfinity bin generated from openscad h…