The first problem, there is an outage in most places right now with printing.
When that is resolved…
- When using the external spool, remember to uncheck the Use AMS option in the print window.
- Your printer came with a PTFE tube that you connect in front of the external spool on the body of the printer
- The other end goes in any hole on the top of the print head, it does not matter which.
- Add the spool to the external spool holder with the filament coming from the bottom and towards you, and push it into and through the PTFE tube.
- On the printer’s display, use the filament option and swap to the external spool tab.
- Use the LOAD button
- The printer will head the hot-end and be ready to push filament in when it gets hot enough, above around 210ºc
- The screen will ask you to do this and to confirm filament is coming out.
- You only need to see it some coming out, you can use some pressure to push it through, nothing too much
- Tell the screen when you have by pressing the button
- Then tell the printer to print