Hot End Bracket Brooke

Bambu Lab A Series Troubleshooting
1

I’m not sure how but half of the bracket that holds the hot end broke off. I just got through a three month repair job where I had to replace that piece six times. I DO NOT want to take that stupid thing apart again.

Is there a trick to getting by without that bracket? I tried but it won’t heat up. Looking for suggestions. I’m even willing to glue it in place!

A1
4mm hot end
Me: too shaky from a disease to be good at fixing printers

2

Can you post a pic, I’m not sure what piece your talking about.

3

I think more detail is needed.
In my job, break once it’s probably the part. More than once it’s probably the design. More than once for the same person says they’re doing something that breaks it.

Please share more.

4

20241123_170251
20241123_1702511920×1896 137 KB

5

There’s a pic. The last six months was Bambu replacing part after part to figure out a problem.