Can anyone help me here. I have had dozens of successful prints with this model. Then I will get a run of broken units. I am using ABS dried. pre-heating the bed to 100c. Switched from textured to smooth plates. used both generic settings and adjusted to a variety of suggested support retraction settings. I print a variety of sizes of this model and I am wondering can the G-code of a session become corrupted? I will have a run for a month of perfect prints then this will happen without any changes? I will swap out filament’s. Re-dry the filament’s. The only remedy is swapping the session and scaling to the particular size needed. Very frustrating. Thanks for any input.
