I simply used a stopwatch.
As soon as the display switched to layer 30, for example, I started the stopwatch, then stopped it when switching to layer 40.
So I had stopped the time for 10 layers.
My error is around 200 to 400%.
When I look at your cube, the current layer is assigned the color code yellow in the “Layer Time” window.
Ok, with a cube each layer has to last the same amount of time.
In your example that corresponds to something between 7 and 9.4 s layer time.
In your G-Code, however, it is 20.8 seconds.
Shouldn’t the layer then be displayed in light green?
I also took a look at my G-Code.
My current layer is displayed in a color that corresponds to a time of 8.8 seconds. My G-Code then says 10.7 seconds. That would be close.
In fact, a layer takes 22 seconds (stopwatch).
Perhaps the pure component time is calculated in the color representation - without the support structures?
I’ll have to take a closer look at this…
L.G.
Frank