Well, if it helps. Using your image, here is the feedback I might offer. What you’ll find in filament calibration is that it is not absolute but rather a sliding scale. So at the bottom of your image, if you let’s say had 10mm from the bottom using the defaults:
What that would mean is that 5mm + (10mm * 0.5) where 10mm is what was measured from the bottom, this would give you a max flow rate of 15mm. What I tend to do is go about 10% less so in this case I would round up for a value of 15-2mm=13. Which is what I would put in my filament profile.
5 Likes