Hi all,
was looking for a case design that prints well on my H2D
have printed many different designs but they keep continuously failing.
any suggestions?
I can design it for you, but I need you to ship me one first so I can measure.
All seriousness (I just though that was a funny comment I saw a few days ago).
How are the ones that you have tried failed? Its hard to give a suggestion without knowing what to make a suggestion about.
@3ndl355 Also mention what filament you used.
If you are referring to a case that is like a phone case, my personal experience says that 3D printed ones are less than idea. I have tried printing cases for my phone from PLA+, PETG and TPU and have only had moderate success at best. The TPU was my worst results, somewhat due to trying to make it look nice but mostly due to the struggle of getting a soft filament print to be the right size. I never did figure out a good method of figuring that out. The PLA+ and PETG both printed well and fit the phone, but neither held up long before starting to break and chip.