Hi,
Pretty new to Bambu Lab and just got a couple of X1E’s. I am trying to do a few test prints and noticed some bridging issues.
When i look at the slices model it seem to have bridged 2 of the 8 bridges on this model at 90° to the correct direction. Shown below in the red circled areas.
I’ve tried to change the Bridge direction setting, which does change the direction, but this is not ideal, as i want it to bridge the full length of the gap.
I have also tried to rotate the model to multiple angles but again no luck.
Any suggestions on how to fix this?
The model is: Print-In-Place Fidget Clicker by Frankee | Download free STL model | Printables.com
Just doing it as a test to check how well the printer functions and immediately ran into this strange issue.