iv been trying to print with pla glow and petg cf but when i go print it just says that the hardness of ________ exceeds the hardness limit of the nozzle. iv also tried printing with the hardend steel nozzle but it doesn’t help
you need the hardened nozzle and SELECT it in the printer settings
You have to go to the settings on the printer itself and under settings → accessories select the proper nozzle. Then check the device page in Studio for Printer Settings, and make sure that it’s seeing the hardened nozzle. This was a challenge that I had as well, and it’s not very straight forward to figure out.
Hope that helps!
1 Like
This is what I do and works. Agree not straightforward.
i have already tried selecting the hardened nozzle and yet it still doesn’t work