Any idea what is going on here? I printed both with my P1S with AMS. Printed the left one first, then the right. What the heck happened?
The red and white are separate parts each object defined with the standard quality settings. Printing with Bambu Lab PLA.
When this started. I found that my nozzle was clogged so I installed a brand new hot end, same poor print quality. It seemed that it was a bed adhesion problem. Installed a new plate. A little better but still not as good as the original. So, I’m reaching out for some help.
Thanks in advance.
and here is what it looks like when it’s printing. what the heck? It was so reliable and with less than 200 hours.
