Hi all, I have an A1 with AMS Lite and I am trying to print a lightbox with 7 different colours on the face.
Is this possible and if so how do I get the printer to pause so I can swap the filaments on the AMS when it needs another colour?
I know about putting pauses into the G-Code but that requires looking down the z access for layer changes, with the lightbox cover all the colour changes are on the same layer, so how can I insert pauses?
Hope this makes sense.
Mike
Hello,
I have linked some resources which could be helpful.
You may need to fuse the 2 solutions by implementing a M400 command into one of the filaments and manually swapping the colours when it pauses.
https://www.reddit.com/r/BambuLab/comments/1ffyc3t/print_multicolour_without_ams_from_bambu_studio/
First glance this looks like what I was after, thank you very much for doing this 
1 Like