Manual entry of K value

That’s another issue.
Just to be safe, are you editing for the correct nozzle size?
If you know the value, you can add it as a calibration result without completing the calibration.

The “cheating” process:

  1. Select manual calibration;
  2. Select the filament to calibrate (also check the nozzle diameter and plate type)
  3. Press calibrate button

You will be forwarded to a new page where the printing process starts.

  1. Press the stop button (red square at bottom)
  2. Confirm that the print was cancelled
  3. Press the next button

You will be forwarded to a new page where you can manually set the k value to a filament name.

  1. Add the k value and filament name and press finish.

You need to do it one by one, but it works.

3 Likes