Mega Mega Clog Around the whole Toolhead

Bambu Lab P Series Troubleshooting
1

I’m new to 3D Printing and the P2S is my first printer. I was attempting to print some soda can openers (pretty thin overall build) and when I cam to check on the print, I found the attached mess on my hands. I was using Bambu PETG-HF filament with a .4 High Flow nozzle.

Plastic is encased all around the nozzle and in the Tool Head. Any adivice on how to best clean this up?

IMG_7585
IMG_75851920×2560 334 KB

2

This will help…

To sum it up, a little bit of heat, tweezers, and patience. A nylon brush helps too if you have one.

2 Likes
3

Thank you so much! How much of the nozzle can get wet?

4

Why do you want to get it wet?

Follow the wiki. Heat the nozzle to 220 and start pealing.

2 Likes
5

That worked…thank you for your help!