Multi-Color failure. 2nd color doesn't apply correct

Bambu Lab Software Bambu Studio
1

Hey there, I own a X1C with AMS. I recently printed a few multicolor prints and everything went fine. I use the “fill” Button in Bambu Studio to color the part I want. The prints are all kind of the same but not identical. I have a black cylinder with a belt in its middle. The belt should be yellow. There was no problem with 2 previous prints but now the third gets messes up. The belt isn’t yellow at all. And the support tower shows a greenish, brown color where the yellow part should be, like the filaments get mixed. My best guess is, that the yellow coloring in the slicer doesn’t go through the whole wall but only the very first layer. In appearance the whole cylinder stays black.

I am sorry I have no picture yet since I am @ work writing this but surely I can upload some in the evening if nessessary.

I hope anyone knows what the problem could be.

Thanks and regards

2

Check the flush volumes. It’s the little button above the colors. In the past, Studio updates occasionally changed the multiplier to “0”.
You can also change individual volumes by clicking the cells in the table and entering a new number.

2 Likes
3

Hey, thank you. You’re right. They were all set to “0”.

Since it is an 12 hours print I can’t tell until tomorrow if it worked.

Greetings

1 Like