Running Ver 2.1.1.52:
I have a request. (Looked through previous messages but did not see this one.)
After updating to the above version of Studio, I find I need to log out/ in every few days, in order to access my filament profiles.
Prior to this, I could go months without ever needing to log off and in. (I tend to leave STudio open nearly all the time, as I’m always working on projects)
If I don’t remember to log off immediately, when I’m ready to send to print, I find only defaults are available, causing a delay as I then need to log cycle.
Not a terrible issue, but not convenient.